Cirrus and water vapour transport in the tropical tropopause layer - Part 2: Roles of ice nucleation and sedimentation, cloud dynamics, and moisture conditions

A high-resolution, two-dimensional numerical model is used to study the moisture redistribution following1 homogeneous ice nucleation induced by Kelvin waves in the tropical tropopause layer (TTL). We compare results for dry/moist initial conditions and three levels of complexity for the representation of cloud processes: complete microphysics and cloud radiative effects, likewise but without radiative effects, and instantaneous removal of moisture in excess of saturation upon nucleation. Cloud evolution and moisture redistribution are found to be sensitive1 to initial conditions and cloud processes. Ice sedimentation leads to a downward flux of water, whereas the cloud radiative heating induces upward advection of the cloudy air. The latter results in an upward (downward) flux of water vapour if the cloudy air is moister (drier) than the environment, which is typically when the environment is subsaturated (supersaturated). Only a fraction (∼25% or less) of the cloud experiences nucleation. Post-nucleation processes (ice depositional growth, sedimentation, and sublimation) are important to cloud morphology, and both dehydrated hydrated layers may be indicators of TTL cirrus occurrence. The calculation with instantaneous removal of moisture not only misses the hydration but also underestimates dehydration due to (i) nucleation before reaching the minimum saturation mixing ratio, and (ii) lack of moisture removal from sedimenting ice particles below the nucleation level. The sensitivity to initial conditions and cloud processes suggests that it is difficult to reach generic, quantitative estimates of cloud-induced moisture redistribution on the basis of case-by-case calculations.